THERMAL ANALYSIS OF COOLING EFFECT ON GAS TURBINE BLADE

Amjed Ahmed Jasim AL-Luhaibi, Mohammad Tariq

Abstract: Performance of a gas turbine is mainly depends on various parameters e.g. ambient temperature, compressor pressure ratio, turbine inlet temperature etc. The most important parameter to increase the life of the turbine blade is the cooling of the blade, which is necessary after reaching a certain temperature of the gases passing through the blades. Various types of cooling models are available for a turbine blade cooling. The power output of a gas turbine depends on the mass flow rate through it. This is precisely the reason why on hot days, when air is less dense, power output falls off. This paper is to analyze the film cooling technique that was developed to cool gases in the initial stages of the turbine blades, where temperature is very high (>1122 K). It is found that the thermal efficiency of a cooled gas turbine is less as compare to the uncooled gas turbine for the same input conditions. The reason is that the temperature at the inlet of the turbine is decreased due to cooling and the work produced by the turbine is slightly decreased. It is also found that the power consumption of the cool inlet air is of considerable concern since it decreases the net power output of gas turbine. In addition, net power decreases on increasing the overall pressure ratio. Furthermore, the reviewed works revealed that the efficiency of the cooled gas turbine largely depends on the inlet temperature of the turbine and previous research said that the temperature above 1123K, require cooling of the blade

Keywords: Gas turbine, Turbine blade cooling, film cooling technique, Thermal Efficiency

DOI: https://doi.org/10.15623/ijret.2014.0303112